Contex FLEX50i - Page 104

Maintenance 8-23
7. Reinsert the new lamp-unit. Rest the power-connector side on the slider and carefully push the lamp-
unit into the scanner.
8. Insert the lamp-unit all the way so the internal power connections engage with the connections on the
lamp-unit.
9. Replace the lamp cover on the scanner - fit the bottom notches in the holes and snap the cover shut.
The cover must always be closed before turning scanner power ON.
Fit the cover’s bottom
notches into the holes
10. Test the replacement by turning power and scanner on to see if the lamp lights.