Using the scanner, how do I … Copy? 5-12
5.3.6 To Create a New Media Profile
(The instructions below are repeated from the section – “Creating Media Profiles - Color Printer Setup”):
If your system does not already have a Media Profile for the media that matches the media in your printer,
then you must create a new Media Profile.
A Media Profile is connected solely to a specific printer and media type so you will need to create new
media profiles if all of these (printer or media) are changed.
On the iJET Panel
1. Select the Menu button.
2. Use the arrow button up or down until the display window shows Advanced and confirm with
the Enter button .
3. Use the arrow buttons up or down until the display shows Options and confirm with .
4. Closed Loop Cal should be displayed as the first option. If not use the arrow down button to reach
it. Press to confirm.
5. Your display should now look like this (the actual text on the 2. line will show the current setting for
the option and may be different than the one shown below).
6. Press to move the “>” mark to the current setting so you can change it. Use the arrow
buttons up/down
until you reach the media type (Coated, Semi Glossy, Glossy…) that
describes the media in your printer. Press to confirm.
7. On “Print Sheet” select Enter. The system will print a color patch sheet.
8. Feed the sheet into the scanner
9. The display will now show “Scan Sheet”. Select to start. The system will scan the color patch
sheet and calculate color matching values for future jobs with the current media type.
10. When you use the system for copying, you will select the option for the Media Type that matches the
media loaded on your printer. This is done through the Menu button. The system will then load the
corresponding Media Profile and use it to create optimal color output for the job.
> Advanced
To Next Page
Loading...
