Maintenance 8-25
8.5.4 Replacing the Dust-Filters
Fresh dust filters can reduce the amount of time spent on cleaning and calibration. The dust filters protect
your scanner’s air-cooling vents. Some scanner models are designed so users can replace the dust
filters. On other models, a service technician must perform this process. See your scanner’s model
specifications to see if the dust filters are user-replaceable on your scanner. Your scanner monitors usage
of the filters and will warn you when it is time for a replacement through a message in the iJET Panel
display window.
Replacing the Dust-filters:
On Scanners: FLEX50i
1. Turn the scanner power off and disconnect the power plug.
2. Locate the square-shaped dust filter bin on the underside of the scanner.
3. Insert a screw-driver or other sharp tool under one of the bin’s edges to snap it down and detach it
from its frame.
4. The filter (soft material) is inside the bin. Remove the old filter and replace with a fresh one.
5. Reattach (click on) the bin to its frame on the underside of the scanner.
To Next Page
Loading...
