iJET Panel Quick Reference Guide 11-14
Scanner Info ->
Scanner Info ->
View Information about the
scanner
Scanner Name
IP Address
FW Release
Scanner Uptime
Serial Number
Service ID
Scanner Name:
The scanner model name and its ID on the
network
IP Address:
The IP of the scanner on the network
FW Release:
Upgradeable firmware version. Version
numbers are increased each time a new
OFFICIAL firmware is released.
Scanner Uptime:
The amount of time your scanner has been
turned on.
Serial Number:
The scanner's serial number. You may be
asked for this number when in contact with a
service/support provider
Service ID:
The scanner's service ID number. You may
be asked for this ID when in contact with a
service/support provider
Timer ->
Timer ->
The timer option is for
programming your scanner’s
internal clock that controls your
scanner’s sleep and wake-up
schedule.
The option lets you program the
scanner to automatically power
on and warm up to optimal
internal temperature when most
convenient for your schedule. In
this way, it stands ready when
you need it.
Monday - Friday
Wake-up Time -
Sleep Time
for each day
Link mon-fr
Yes, No
Default: No
Sleep
Enabled/Disable
d
Default: Enabled
Sleep Delay
Default 15.
Monday – Friday
Set wake-up and sleep time for each day as
hh:mm. AM and PM can be set if AM/PM time
format is selected as scanner’s time format.
Link mon-fri
option to make your settings for Monday apply for
the whole work-day-week
Sleep Mode ->
Sleep Mode ->
The option lets you set the
scanners Sleep mode settings
Sleep
Enabled/Disable
d
Default: Enabled
Sleep Delay
Default 15.
Sleep
This functionality is in addition to the Timer clock
function, to enter Sleep Mode automatically
after an idle time.
Sleep Delay
Set the time delay (idle time) for the Sleep
function above. Settings 1 – 60 minutes. The
scanner will go into Sleep mode if it stands idle
for the time specified.
To Next Page
Loading...
