Configuration and Setup 3-19
5. Use arrows down/up until the display shows Media Handling and confirm with .
6. Your display should look like this (the actual text to the right of the “>” will show the current setting
for the option and may be different than the one shown below).
7. Use arrows down/up to select the method you want to use and confirm with . Auto
Load means the scanner will pull the original into the scan area as soon as you insert it into the slot.
You can set a Load Delay factor with Auto Load (see next step). Manual Load means you insert the
original and press on the panel’s feed forward button.
8. Delay Factor: If you selected Auto Load and want to change the delay factor – Make sure the Media
Handling option is marked with the “>”. If not press enter to move it up. Use arrow down to reach
the Load Delay option. Confirm with Enter . Use the arrows to set a Load Delay
factor and confirm with . These steps are illustrated below.
9. Soft Handling: Back-step and use the arrow down to reach the Soft Handling option. Press Enter.
Your device is designed to scan at very high speeds for maximum efficiency. However, some old,
curled or creased originals can trigger a paper jam when fed and scanned at high speeds. You may
also have a fragile original that you want passed delicately through the drive system. With the Soft-
handling option selected, both feeding and scanning are slowed down to enable smooth scanning of
curled, creased, frayed or fragile originals. Use the arrows to select Yes or No to Soft Handling and
press Enter to confirm.
10. Media Offset: Back-step and use the arrow down to reach the Soft Handling option. Press Enter.
The scanner media offset determines the left, top and bottom points of the scanning range. The
media offset is set during production, but you can correct slight offset irregularities if they occur.
Press Enter to reach each setting Side Offset, Top Offset, Bottom Offset and use the arrows to set
values (Defaults = 0). An offset value over 0 in the Side Offset field means that the scanning field’s
side reference point is moved towards the middle. An offset value over 0 in the Top Offset or Bottom
Offset fields mean that the scanning field’s top or bottom point is moved down.
Media Offset
To Next Page
Loading...
