Maintenance Manual SP 40
Rev. 005
i.6 Index
ILLUSTRATIONS
Page
Fig. 3.12a Initial mask for SP40setup installation 68
Fig. 3.12b Other mask for SP40setup installation 68
Fig. 3.12c Other mask for SP40setup installation 69
Fig. 3.12d Other mask for SP40setup installation 69
Fig. 3.12e Other mask for SP40setup installation 69
Fig. 3.12f Other mask for SP40setup installation 70
Fig. 3.12g Other mask for SP40setup installation 70
Fig. 3.13 Initial mask for SP40setup application 70
Fig. 3.14a Read NVM mask of the SP40setup application 71
Fig. 3.14b Read NVM mask of the SP40setup application 71
Fig. 3.15 Write NVM mask of the SP40setup application 72
Fig. 3.16 Button to print NIC Configuration 74
Fig. 3.17 Network Interface Configuration 74
Fig. 4.1 Basic FW steps through LAN using FTP 80
Fig. 4.2 Power Supply pin-out 84
Fig. 5.1 Operator Panel Sketch 87
Fig. 5.2 Schematic flow-chart of the T&D USER in Step by Step mode 90
Fig. 5.3 Operator Panel with Display for T&D activities 102
Fig. 5.4 Serial I/F loop-back 102
Fig. 5.5 Parallel I/F bi-directional loop-back 103
Fig. 5.6 Pattern for Printout T&D9 of standard model (reduced) 104
Fig. 5.7 Pattern for Printout T&D9+T&D10 of Standard model (reduced) 107
Fig. 5.8 Remoter mode display (Hyper Terminal under W98) 108
Fig. 5.9 Remote mode display (Sensor 2 error during T&D9) 109
Fig. 5.10 Remote mode display (Sensor 4 error during T&D9) 110
Fig. 5.11 Remote mode display (Sensor 8 error during T&D9) 110
Fig. 5.12 Example of T&D12 Log File (without errors) 112
Fig. 5.13 Example of T&D12 Log File (with maximum N° of errors) 112
Fig. 6.1 Single Sheet dimensions 114
Fig. 6.2 Passbook Dimensions 115
Fig. 6.3 Horizontal Passbook 116
Fig. 6.4 Vertical Passbook 117
Fig. 7.1 Print Head Architecture 119
Fig. 7.2 Print Head Connection (rear view) 120
Fig. 7.3 Needles Position (rear view) 121
Fig. 7.4a P.H. Operation 121
Fig. 7.4b P.H. Operation 121
Fig. 7.5 Carriage Motor Layout 122
Fig. 7.6 Paper Motor Layout 123
Fig. 7.7 Selector Motor Layout 124
Fig. 7.8 Home Position Sensor 125
Fig. 7.9 Edge Sensor 126
Fig. 7.10 Ribbon Sensor 126
Fig. 7.11 Sensor Board and Optical Fibre 127