Curtis 1236SE User Manual

Curtis 1232E/34E/36E/38E & 1232SE/34SE/36SE Manual, os 30
121
24 NOVEMBER 2015
8 — VCL
Status5
* Bit0 = External Supply Out of Range (Code 69)
* Bit1 = Motor Temp Sensor Fault (Code 29)
* Bit2 = VCL Run Time Error (Code 68)
* Bit3 = +5V Supply Failure (Code 25)
* Bit4 = OS General (Code 71)
* Bit5 = PDO Timeout (Code 72)
* Bit6 = Encoder Fault (Code 36)
* Bit7 = Stall Detected (Code 73)
Status6
* Bit0 = Bad Calibrations (Code 82)
* Bit1 = [Not Used]
* Bit2 = Emer Rev HPD (Code 47)
* Bit3 = [Not Used]
* Bit4 = Motor Type Fault (Code 89)
* Bit5 = Supervisor Fault (Code 77)
* Bit6 = Motor Characterization Fault (Code 87)
* Bit7 = [Not Used]
Status7
* Bit0 = [Not Used]
* Bit1 = VCL/OS Mismatch (Code 91)
* Bit2 = EM Brake Failed to Set (Code 92)
* Bit3 = Encoder LOS (Limited Operating Strategy) (Code 93)
* Bit4 = Emer Rev Timeout (Code 94)
* Bit5 = Dual Severe Fault (Code 75)
* Bit6 = Fault On Other Traction Controller (Code 74)
* Bit7 = Illegal Model Number (Code 98)
Status8
* Bit0 = [Not Used]
* Bit1 = [Not Used]
* Bit2 = [Not Used]
* Bit3 = Parameter Mismatch (Code 99)
* Bit4 = Severe KSI Undervoltage (Code 17)
* Bit5 = [Not Used]
* Bit6 = [Not Used]
* Bit7 = Encoder Pulse Count Fault (Code 88)
Status9
* Bit0 = Supervisor Incompatible (Code 78)
* Bit1 = [Not Used]
* Bit2 = [Not Used]
* Bit3 = [Not Used]
* Bit4 = [Not Used]
* Bit5 = [Not Used]
* Bit6 = Driver Supply Fault (Code 83)
* Bit7 = Following Error (Code 48)

Curtis 1236SE Specifications

General

Brand	Curtis
Model	1236SE
Category	Controller
Language	English