Curtis 1236SE - Clear_Digout(); Set_Digout()

128
Curtis 1232E/34E/36E/38E & 1232SE/34SE/36SE Manual, os 30
24 NOVEMBER 2015
8 — VCL
SET_DIGOUT()
This function turns on the selected digital output. The digital outputs are active low
(On = driver on and pulled to ground, Off = open circuit at the pin).
Syntax Set_Digout(DigOut_ID)
Parameters
DigOut_IDisthedigitaloutputidentication.
DigOut6 = Digital Output 6 (pin 19).
DigOut7 = Digital Output 7 (pin 20).
Returns
0 – Selected digital output not set.
1 – Selected digital output successfully set.
Error Codes
Bad_ID is returned when DigOut_ID is not in the range of DigOut6 to
DigOut7.
Example Set_Digout(DigOut6)
This example will set Digital Output 6 (pin 19) On (active low, pulled to ground).
CLEAR_DIGOUT()
This function turns off the selected digital output. The digital outputs are active low
(On = driver on and pulled to ground, Off = open circuit at the pin).
Syntax Clear_Digout(DigOut_ID)
Parameters
DigOut_IDisthedigitaloutputidentication.
DigOut6 = Digital Output 6 (pin 19).
DigOut7 = Digital Output 7 (pin 20).
Returns
0 – Selected digital output not cleared.
1 – Selected digital output successfully cleared.
Error Codes
Bad_ID is returned when DigOut_ID is not in the range of DigOut6 to
DigOut7.
Example Clear_Digout(DigOut6)
This example will set Digital Output 6 (pin 19) Off (open circuit).