Curtis 1236SE User Manual

Curtis 1232E/34E/36E/38E & 1232SE/34SE/36SE Manual, os 30
17
24 NOVEMBER 2015
2 — INSTALLATION & WIRING: Throttle Wiring
Throttle Type 5
rottle Type 5 provides a dierent way of sending the throttle command to
the controller. is throttle type uses VCL to define the throttle signal that
will be “input” into the throttle signal chain (see Figure 15, page 114). is
throttle type can be used for either the drive throttle or the brake throttle by
using the VCL variables VCL_rottle and VCL_Brake. How the VCL pro-
gram is written will determine the source of the throttle signal, making this
a very exible throttle input method. VCL can be written to use the throttle
pot inputs, switch inputs, or CAN communication messages as the source of
the throttle signals. If you have questions regarding this throttle type, contact
your Curtis distributor or support engineer.
Setting the rottle Type to Type 5 also allows the throttle and brake
pot inputs to be redefined by a VCL program for uses other than throttle or
brake input.

Curtis 1236SE Specifications

General

Brand	Curtis
Model	1236SE
Category	Controller
Language	English