To Next Page

To Previous Page

9-4

A.C GENERATOR / STARTER CLUTCH

SAI PIPE

SAI TUBE

COOLING FAN

STARTER COMP

RH. CRANK CASE COVER

SAI REED VALVE

A.C GENERATOR INSTALLTION

● Install the stator to the RH. Crankcase cover.

● Clean the tapered portion of the crankshaft.

● Clean the inside part of the flywheel.

● Check the woodruff key, install the flywheel by

aligning the groove with the woodruff key.

● Temporarily install the flywheel nut, hold the flywheel

with the universal holder, or remove the LH. crankcase

cover and tighten the flywheel nut with the specified

torque.

TORQUE VALVE : 5.0~6.0kgf m

TOOL : UNIVERSAL HOLDER

● Hold the drive face with drive face holder and install

the cooling fan.

● Install the LH. crankcase cover.

TORQUE : 0.8~1.2kgf m

● Install the RH. Shroud.

● Connect the A.C.G wiring coupler and connector to the

wire harness, and install the wiring with the clamp.

● Install rear under cover.

● Install the muffler.

RH. CRANKCASE COVER

● Remove the following parts.

- Rear under cover.

- Ex. Muffler.

- Rear swing arm.

- RH shroud.

- Cooling fan.

- A.C.G starter comp.

- SAI reed valve.

● Loosen the flange bolt securing the RH. Crankcase

cover.

● Remove the RH crankcase cover.

Brand	DAELIM
Model	B-BONE
Category	Scooter
Language	English

DAELIM B-BONE Service Manual

Table of Contents

Other manuals for DAELIM B-BONE

Questions and Answers:

DAELIM B-BONE Specifications

Related product manuals