To Next Page

To Previous Page

15-3

BRAKE SYSTEM

FRONT BRAKE AIR BLEEDING

● Fill the reservoir with DOT 3 or 4 brake fluid up to the

upper level.

● Remover the fluid maintenance lid.

● Remove the oil cup cap, diaphragm plate, and

diaphragm from the master cylinder.

● Connect the bleeder hose to the bleeder valve. Loosen

the bleeder valve, and pump the brake lever repeatedly.

● When there is no more fluid flowing out of the bleeder

valve. Stop pumping the brake lever.

● Connect the recommended brake bleeder to the bleeder

valve.

● Loosen the bleeder valve while pumping the brake

lever.

● Repeat this operation until the brake fluid flows out of

the brake bleeder.

● Add brake fluid.

● Repeat the above procedures until no air bubbles

appear in the bleeder hose.

● Squeeze the bleeder valve and operate the brake lever

to check the ingress of air.

MASTER CYLINDER

FR. BRAKE BREEDER VALVE

CALIPER

BREEDER VALVE

FR. BRAKE MASTER CYLINDER

FRONT BRAKE LEVER

BRAKE BREEDER

BRAKE FLUID

●A contaminate disk or pad reduces braking

power. Do not allow the disk or pad to be

contaminated by oil.

●Replace contaminated pads, and remove

pollutants from the disk completely.

●Check the brake fluid level often and replenish

new fluid as required.

●Do not spill fluid on painted, plastic or rubber

parts.

CAUTION

△

●To prevent chemical changed.Do not use

different type of brake fluid.

CAUTION

△

BRAKE FLUID

●Check the fluid level often and replenish fluid

if the amount of fluid is reduced to the lower

level.

●Read the user’s manual carefully prior to

disassembling or using the brake bleeder.

●Protect the bleeder valve with tape to prevent

air from entering the bleeder valve.

NOTE

△

Brand	DAELIM
Model	B-BONE
Category	Scooter
Language	English

DAELIM B-BONE Service Manual

Table of Contents

Other manuals for DAELIM B-BONE

Questions and Answers:

DAELIM B-BONE Specifications

Related product manuals