Dahua DH-PFS6428-24T - Storm-Control Broadcast PPS; Storm-Control Multicast PPS

network.
6.7.1 storm-control broadcast pps
Command Description
storm-control broadcast pps vlaue
//This command is used to enable the broadcast storm control function.
no storm-control broadcast
//This command is used to disable the broadcast storm control function.
Parameter
Parameter
Parameters of the command mode
Value
Range:0-1000000 unit:pps,Default: 0
Default
None
Command Mode
Interface configuration mode
Example
//This command is used to limit the rate of broadcast packet of Port 1 to
1000pps.
switch(config)# interface G1
switch(config-G1)# storm-control broadcast pps 1000
6.7.2 storm-control multicast pps
Command Description
storm-control multicast pps vlaue
//This command is used to enable the multicast storm control function.
no storm-control multicast
//This command is used to disable the multicast storm control function.
Parameter
Parameter
Parameters of the command mode
value
Range:0-1000000 unit:pps,Default: 0
Default
None
Command Mode
Interface configuration mode
Example
//This command is used to limit the rate of multicast packet of Port 1 to
1000pps.