8. System maintenance commands
8.1 Reboot
Function Brief
This chapter describes the device restart commands.Please pay
attention to the configuration save operation Before using this command.
8.1.1 reboot
Command Description
reboot
// This command is used to restart the equipment.
Parameter
None
Default
None
Command Mode
Privileged mode
Example
switch# write
switch# reboot
//Run the following commands to save the configuration, and then restart
the equipment.
8.2 Restore factory
The command for restoring factory settings is as follows:
default configure
default configure keep-ip
Function Brief
This chapter describes the recovery of the factory configuration
command. This command can be used to restore the factory configuration,
the configuration will be returned to the default value.
To Next Page
Loading...
Need help?
General