//This command is to add or delete the static routing.
switch(config)# ip route 0.0.0.0/8 0.0.0.0 1
switch(config)# no ip route 0.0.0.0/8 0.0.0.0 1
switch(config)# ip route 10.0.0.2 10.255.255.255.0 10.0.0.1 1
switch(config)# no ip route 10.0.0.2 10.255.255.255.0 10.0.0.1 1
5.2.2 show ip route
Command Description
show ip route:
//This command is used to display the static routes.
Parameter
None
Default
None
Command Mode
Privileged mode
Example
//Display the static routes.
switch# show ip route static
S>* 0.0.0.0/8 [1/0] via 192.168.255.1, vlanif1 S>* 0.0.0.0/8 [1/0] via 192.168.255.1,
vlanif1
5.2.3 example
This command is used to realize trans-network segment communication
between PC1 and PC2 through a static route.
sw1: switch# configure terminal
switch(config)# interface vlan1
switch(config-vlanif1)# ip address 192.168.1.1 /24
switch(config-vlanif1)# exit
To Next Page
Loading...
Need help?
General