Dahua DH-PFS6428-24T - Passive-Interface Default; Redistribute

switch(config-ospf)#default-metric 111
//This command is to configure OSPF default-metric for 111.
5.3.6 passive-interface default
Command Description
passive-interface default
//This command is to configure OSPF passive-interface default.
no passive-interface default
//This command is disable the OSPF passive-interface default.
passive-interface IFNAME
//This command is enable OSPF passive ports.
no passive-interface IFNAME
//This command is disable OSPF passive ports.
Parameter
Parameter
Parameters of the command mode
IFNAME
Port,Example G1,T1
Default
None
Command Mode
Global configuration mode
Example
switch(config-ospf)#passive-interface T1
//This command is the T1 for passive-interface.
5.3.7 redistribute
Command Description
redistribute RIP|static|connected
no redistribute RIP|static|connected
//The external routing is fully distributed into the OSPF network.
Parameter
None
Default
None
Command Mode
Global configuration mode
Example