3.2.1 rate-limit
Command Description
rate-limit {1-10000000 } egress/ingress
no rate-limit egress/ingress
//Configure port egress / ingress speed limit function, use the no form, port restore
default settings .
Parameter
Port speed range is 1-10000000kbps
Default
0
Command Mode
Interface configuration mode
Example
//The speed limit exports 10000 Kbps
switch(config)#interface G1
switch(config-G1)# rate-limit 10000 egress
3.3 Port mirroring
Function Brief
Port mirroring is also called port monitoring. Port monitoring is a data
packet acquisition technology. It can be configured on a switch to copy data
packets from one or more ports (mirror source ports) to a specified port
(mirror destination port). The destination port is connected to a host installed
with the packet analysis software. The software analyzes the collected
packets to implement network monitoring and eliminating network faults.
3.3.1 monitor
Command Description
monitor session <1-4> ingress destination <IFNAME> source
<IFNAME>
no monitor session <1-4>
//Configure port mirroring function, use the no form of the command, delete the
image settings.
Parameter
Parameters of the command mode
To Next Page
Loading...
Need help?
General