//This command is to set the OSPF redistribution RIP.
switch(config-ospf)#redistribute RIP
//This command is to set the OSPF redistribution static.
switch(config-ospf)#redistribute static
//This command is to set the OSPF redistribution connected.
switch(config-ospf)#redistribute connected
5.3.8 default-information originate
Command Description
default-information originate [always] [metric] [metric-type] [route-map]
no default-information originate [always] [metric] [metric-type] [route-map]
//default-information originate command is used to configure the local router to
generate a default OSPF routing and related parameters, and to notify the neighbors.
//no default-information originate command is used to cancel the generation of the
default route or to change the associated parameters.
Parameter
Always notify the default route.
Notice the cost of the default route.
Notice the type of default route, the value of 1
or 2, the default is 2.
Notice the default route to call the route-map
rule.
Default
None
Command Mode
OSPF configuration mode
Example
//Configure OSPF process 11 to generate a default route for metric 12:
switch(config-ospf-11)#default-information originate metric 12
5.3.9 ip ospf
Command Description
Ip ospf cost/network/priority/hello-interval/dead-interval/authentication/
authentication-key
To Next Page
Loading...
Need help?
General