//This command is used to disable the HTTP service on the switch. After
this command is executed, the switch cannot be managed in HTTP mode.
Parameter
None
Default
None
Command Mode
Global configuration mode
Example
//Enable the HTTP service.
switch(config)# ip http-server https
7.2 SNMP config
SNMP configuration commands include:
community
syscontact
syslocation
sysname
trap
trap2sink
trapsink
user
Function Brief
SNMP is a set of network management standards. It includes an
application layer protocol, a database schema, and a set of data objects. It is
widely used in network management systems to monitor network-attached
devices for conditions that warrant administrative attention. It is a
component of the Internet Protocol Suite as defined by the Internet
Engineering Task Force (IETF).
7.2.1 snmp
Command Description
snmp
// This command is used to enable the SNMP function.
no snmp
//This command is used to disable the SNMP function.
To Next Page
Loading...
Need help?
General