8.2.1 default configure
Command Description
default configure
//This command is used to restore factory settings of the switch. After this
command is executed, the equipment automatically restarts and the factory
settings are successfully restored.
Parameter
None
Default
None
Command Mode
Privileged mode
Example
//Restore factory settings, and the factory settings take effect after the
equipment automatically restarts.
switch# default configure
8.3 Config management
Function Brief
This chapter describes the configuration file save command. This
command can save the configuration.
Use commands of this chapter to configure the example, please
read the final sample section of the document.
8.3.1 write
Command Description
write
//If you want to save the configuration of the switch, you can configure it
through this command.
Parameter
None
Default
None
Command Mode
Privileged mode
Example
To Next Page
Loading...
