Dahua DH-PFS6428-24T - SNTP Enable;Disable; SNTP Unicast-Server

Function Brief
When enabled, this function can be used to automatically
synchronize the switch time with the network time.
2.3.1 sntp enable|disable
Command Description
ntp:
//This command is used to enable the NTP function.
no ntp:
//This command is used to disable the NTP function.
Parameter
None
Default
Disable
Command Mode
Global configuration mode
Example
switch(config)#sntp enable
switch(config)#sntp disable
2.3.2 sntp unicast-server
Command Description
sntp unicast-server A.B.C.D
//This command is used to add the IP address of an NTP server.
no sntp unicast-server A.B.C.D
//This command is used to delete the ip address of an NTP server.
Parameter
None
Default
None
Command Mode
Global configuration mode
Example
Switch(config)#sntp unicast-server 210.21.196.6