interface trunk [trunk ID]
Configuration trunk
trunk [trunk ID]
Default
None
Command Mode
Global configuration mode
Example
switch(config)# interface trunk 1
switch(config)# interface G1
switch(config-G1)# trunk 1
3.4.2 load-balance
Command Description
load-balance
//This command is to set up static aggregation of load balance mode.
Parameter
Based on the source mesh MAC load balancing
Based on the destination MAC load balancing
Based on the source MAC load balancing
Default
Disable
Command Mode
Interface configuration mode
Example
//This command is to set up load balancing model based on source and
destination MAC.
switch(config)# load-balance both-mac
3.4.3 lacp enable | disable
Command Description
lacp enable
//This command is used to enable dynamic aggregation of ports.
lacp disable
//This command is used to disable dynamic aggregation of ports.
Parameter
To Next Page
Loading...
Need help?
General