3.1.2 speed
Command Description
speed {10 | 100 | 1000|10000|auto }
no speed
//It is used to set the port rate.
Parameter
Parameters of the command mode
The port rate is set to 10M, 100M and 1000M.
The port rate is set to Auto.
Default
By default, the speed mode is set to auto for an electric port,
10000M for a f-port fiber port
Command Mode
Interface configuration mode
Note:
Port speed of light is coerced into 1000M and 10000M.
Electricity mouth can only set auto, 10M and 100M
Example
// The port rate of G1 is set to 100M.
switch(config)# interface G1
switch(config-G1)# speed 100
3.1.3 flow-control
Command Description
flowctrl
no flowctrl
//This command is used to enable or disable the flow control function of a
port.
Parameter
None
Default
The flow control function is enable by default
Command Mode
Interface configuration mode
Example
//enable the function.
switch(config-G1)# flowctrl
To Next Page
Loading...
Need help?
General