If it is the IP channel, right click mouse and click Color, system pops up IPC config
interface. Refer to chapter 4.16.1 for detailed information.
Step 1 On the preview window, right click mouse and then select Color.
Enter the following interface. See Figure 4-55.
Figure 4-55
Please refer to the following sheet for detailed information.
There are two periods in one day. You can set different
sharpness, brightness, and contrast setup for different
periods.
It is for the camera installed auto iris. This function is
enabled by default.
Check the enable box to enable auto iris function.
The auto iris changes accordingly when the light
changes.
Check the disable box to disable auto iris function.
The iris is at the max value. The auto iris adjustment
is off during the exposure control process.
Change video left/right video. This function is disabled
by default.
Flip the video according to the requirements. The flip
degrees depend on the connected camera.
To Next Page
Loading...
