Add: Under specified window split mode, click it to add channel group.
Delete: Click it to remove selected channel group.
Move up: Click it to move current selected channel up.
Move down: Click it to move current selected channel down.
Default: Click it to restore default setup.
Figure 4-62
Step 3 Click Apply or Save to complete setup.
Use mouse or Shift button to switch and button to enable /disable
tour.
means the tour funciton is enabled and meas tour funciton is
disabled. Use mouse click the icon or the “Shfit” button on the remote control
to set.
On the navigation bar, click or to enable/disable tour function.
4.2.9.2 Video Matrix
It is to set matrix video output, tour channel and its interval. It is to set VIDEO OUT port
tour and its interval
Step 1 From main menu->Setting->System->Video matrix.
Enter video matrix interface. See Figure 4-63.
Step 2 Set parameters.
Enable tour: Check the box here to enable this function.
Interval: Input proper interval value here.
To Next Page
Loading...
