Dahua HCVR8204A-S3 - Page 276

266
Please refer to chapter 5.5 Preview,, chapter 5.7 setup , chapter 5.8 search, chapter 5.9
Alarm, chapter 5.6 Face search and chapter 5.11 Logout for detailed information.
Figure 5-9
5.5.1.2 Real-time Monitor
Left click the channel name on the left pane of the main interface; you can see the
corresponding video in current window.
On the top left corner, you can view device IP, channel number, network monitor bit stream.
See Figure 5-10.
Figure 5-10
Please refer to the following sheet for detailed information.
SN
Name
Function
1-4
Display device
information
When there is video, it is to display “Device IP-Monitor
channel number-network bit stream-decode mode”.
Otherwise, it shows as “No video”.
5
Smart track
Click it to view the smart track video.
6
Fisheye
Click it to set fisheye installation mode and display
mode.
7
Digital zoom
Click this button and then left drag the mouse in the
zone to zoom in. right click mouse system restores
original status.
8
Local record
When you click local record button, the system begins
recording and this button becomes highlighted. You
can go to system folder RecordDownload to view the
recorded file.