Dahua HCVR8204A-S3 - Page 300

290
Figure 5-41
Step 2 Set parameters.
Step 3 Click Save to complete the setup.
5.7.1.5 Channel Type
Note
Please note this function is for some series product only. Slight different maybe found on
the user interface.
From main menu->Setting->Camera->Channel type, the interface is shown as below. See
Figure 5-42 (HCVR series product) or Figure 5-43(XVR series product). It is to set channel
type.
 Analog channel (CVBS signal or HDCVI signal and etc.): Please select the
corresponding cable and then save. There is no need to reboot.
 Device supports IP channel. The network camera connection shall begin with the last
channel. Please note DVR needs to restart to activate new setup.
Note
 Analog channel (CVBS signal or HDCVI signal and etc.): Please select the
corresponding cable and then save. There is no need to reboot.
 Device supports IP channel. The network camera connection shall begin with the last
channel. Please note DVR needs to restart to activate new setup.
 Add IP channel function refers to the extra IP channel amount except current channel
total amount (analog+IP). Different series products may support different extra IP
channel amount. For 16-channel series product (16 analog channel+48 IP channel),
check the channel 17 to channel 64, it is to change these channels to IP channels.