It is to connect to the 3G/4G network to receive alarm information, view device state,
audio/video and etc.
5.7.2.4.1 CDMA/GPRS
Step 1 From main window->Setup->Network->3G/4G.
Enter 3G/4G interface is shown as in Figure 5-59.
Note
After you connected the 3G/4G module, you can view the module information and
wireless signal. If there is no information, click Search button to search.
Figure 5-59
Step 2 Check the Boot up box to enable this function and then set parameters.
Here you can select 3G/4G network type to distinguish the
3G/4G module from different ISP. The types include WCDMA，
CDMA1x and etc.
Here is the important parameter of PPP.
It includes PAP,CHAP,NO_AUTH.
It is to set time to end 3G/4G connection after you close extra
stream monitor. For example, if you input 60 here, system ends
3G/4G connection after you close extra stream monitor 60
seconds.
Important
If the pulse interval is 0, then system does not end 3G/4G connection
after you close the extra stream monitor.
Pulse interval here is for extra stream only. This item is null if you are
using main stream to monitor.
Step 3 Check Dial/SMS activate
To Next Page
Loading...
