When the UPNP is offline, it shows as “Searching”. When the UPNP
works it shows “Success”
It is the same information on the UPnP list of the router.
Service name：Defined by user.
Protocol： Protocol type
Internal port：Port that has been mapped in the router.
External port：Port that has been mapped locally.
Note
When you are setting the router external port, please use
1024~5000 port. Do not use well-known port 1~255 and the
system port 256~1023 to avoid conflict.
When there are several devices in the same LAN, please arrange
the port mapping properly in case several devices are mapping to
the same external port.
Please make sure the mapping port is available.
For the TCP and UDP, please make sure the internal port and
external port are the same to guarantee the proper data
transmission.
Click ，you can change WAN port value.
Step 4 Click Save button.
After setting UPnP, open the browser and then input http://WAN IP：External IP
port to access the device.
5.7.2.10 SNMP
SNMP is an abbreviation of Simple Network Management Protocol. It provides the basic
network management frame of the network management system. The SNMP widely used
in many environments. It is used in many network device, software and system.
Preparation
Install corresponding software tool such as MIB Builder and MG-SOFT MIB Browser.
Contact technical engineer to get two MIB files of the current version.
Steps
Step 1 From main window->Setup->Network->SNMP.
Enter SNMP interface is shown as in Figure 5-66.
To Next Page
Loading...
