Please check the box here to enable this function.
This function allows the system to send out the test email to
check the connection is OK or not.
Please check the box to enable this function and then set the
corresponding interval.
System can send out the email regularly as you set here.
The system will automatically sent out a email once to test the
connection is OK or not .Before the email test, please save the
email setup information.
Step 3 Click Save to complete the setup.
5.7.2.9 UPnP
It is to establish the mapping relationship between the LAN and the public network.
Step 1 From main window->Setup->Network->TCP/IP, change IP address to the router
private IP such as 192.168.1.101 or enable DHCP function to automatically get
IP address.
Step 2 From main window->Setup->Network->UPnP.
Enter UPnP interface. See Figure 5-65.
Figure 5-65
Step 3 Enable UPnP and PAT function.
Refer to the following table to set parameters.
Check the box to enable/disable this function.
It is the router IP in the LAN.
Device can auto get the IP address
if the UPnP function succeeded.
Do not need to set.
It is the router IP in the WAN.
To Next Page
Loading...
