When 3G/4G network connection is OK, system can send out a
message when motion detect occurs.
If you enabled this function, System can send out an email to alert
you when an alarm occurs.
You need to check the box here to enable this function. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs.
Here you can set PTZ movement when alarm occurs. Such as go
to preset X. See Figure 5-76.
Check the box here, system can record motion detect event log.
Step 3 Click Save to complete the setup.
5.7.3.1.2 Video Loss
After analysis video, system can generate a video loss alarm when the detected moving
signal reached the sensitivity you set here.
Please note video loss does not support anti-dither, sensitivity, region setup.
Step 1 From main window->Setup->Event->Video detect->Video loss.
Enter video loss interface. See Figure 5-77.
Figure 5-77
Step 2 Refer to chapter 5.7.3.1.1 motion detect for detailed parameter information.
Note
To Next Page
Loading...
