Dahua HCVR8204A-S3 - Page 376

366
Figure 5-138
Step 2 Set parameters.
Parameter
Function
Enable
This function is disabled by default. Check the box here to enable
this function so that you can control the zero-channel encoding
function at the WEB.
Compression
System default setup is H.264. You can set according to device
capability.
Resolution
The resolution value may vary due to different device capabilities.
Please select from the dropdown list.
Frame rate
The frame rate value may vary due to different device capabilities.
Please select from the dropdown list.
Bit Rate
The default setup is 1024Kb/S. The bit rate value may vary due to
different device capabilities and frame rate setups. Please select
from the dropdown list.
Step 3 Click Save to complete the setup.
 If this function is disabled, you cannot operate zero-channel encoding function at
the WEB, the video is black or null even you operate when the function is
disabled.
 After you enabled this function, you can use WEB to view the corresponding
video.
Step 4 Login the Web and you can select zero-channel encoding mode at the right
corner of the interface . Select a mode; you can
view the local preview video.
5.7.5.3 Video Matrix
It is to set video output channel and interval.
Step 1 From main menu->Setup->System->Video matrix.
Enter Video matrix interface is shown as in Figure 5-139.