Figure 5-139
Step 2 Set parameters.
Check the box here to enable this function.
It is to set the interval from current channel group to the next
channel group.
Please select from the dropdown list. Please note the different
series products support different window split mode.
Select a channel group and then click to delete it.
Click or to adjust channel tour sequence.
Step 3 Click Save to complete the setup.
Add channel group
Click ,you can see system pops up the following dialogue box. See Figure 5-140.
Please select the channels and then click OK button.
Figure 5-140
Delete channel group
Select a channel group and then click ,you can delete it.
Modify channel group
Select a channel group and then double click, you can see the following interface. See
To Next Page
Loading...
