Dahua HCVR8204A-S3 - Page 378

368
Figure 5-141. You can change the setup and then click OK button.
Figure 5-141
Adjust channel group sequence.
Click or to change channel sequence.
5.7.5.4 RS232
Step 1 From main menu->Setup->System->RS232.
Enter RS232 interface. See Figure 5-142.
Figure 5-142
Step 2 Set parameters.
Parameter
Function
Protocol
Select the corresponding dome protocol. Default setup is console.
 Console is for you to use the COM or mini-end software to debug.
 The control keyboard is for you to control the device via the
special keyboard.
 Transparent COM (adapter) is to directly connect to the PC to
transfer data. Protocol COM is for card overlay function.
 Network keyboard is for you to use the special keyboard to
control the device.
 PTZ matrix is to connect to the peripheral matrix control.
Baud Rate
Select the baud rate.
Default setup is 115200.
Data Bit
The value ranges from 5 to 8.
Default setup is 8.
Stop bit
There are three options: 1/1.5/2.
Default setup is 1.