There are five options: none/odd/even/space/mark.
Default setup is none.
Step 3 Click Save to complete the setup.
5.7.5.5 PTZ
Before setup, please check the following connections are right:
PTZ and decoder connection is right. Decoder address setup is right.
Decoder A (B) line connects with DVR A (B) line.
Step 1 From main menu->Setup->System->PTZ.
Enter PTZ interface. See Figure 5-143 (local channel) and Figure 5-144 (remote
channel).
Figure 5-143
Figure 5-144
Step 2 Set parameters.
Select speed dome connected channel.
There are two types: local/remote. Please select local mode if you are
connect RS485 cable to connect to the Speed dome (PTZ). Please
select remote mode if you are connecting to the network PTZ camera.
To Next Page
Loading...
