Dahua HCVR8204A-S3 - Page 381

371
Enter Add interface. See Figure 5-146.
Figure 5-146
Step 3 In Figure 5-146, click the Enable box to enable POS function and then set
parameters.
Parameter
Function
Name
Input POS name. System max supports 63 English letters.
Connection type
This is for net mode only. Click Setup button, you can set source
IP (POS IP address), port is the POS port. Destination IP is the
DVR default Ethernet card IP, port is the POS port (read-only).
See Figure 5-147.
Network time out:
If there is a network problem, DVR can wait for the specified time
you set here to send out the POS information. Once the network
time is out, DVR only send out current valid POS information
when then network resumes normal.
Time display
It is to set the POS information displayed time on the video. If you
set 5 seconds, then the POS information appears after 5 seconds
display.
Channel Set:
Click it to go to Figure 5-148. Select a channel you want to
overlay POS information and then click Save button
Click Setup button after the connection mode, the interface is shown as in Figure 5-147.
Here you can set source IP (POS device IP address) and source IP (DVR IP address).