Startup wizard: After initialize the device, system goes to the startup wizard interface.
See Figure 4-12.
Configuration wizard: On the preview interface, right click mouse and then click
configuration wizard. The setting items are the same as the startup wizard.
Figure 4-12
Note
Check the box Startup button here, system goes to startup wizard again when it boots
up the next time.
Cancel the Startup button, system goes to the login interface directly when it boots up
the next time.
From main menu->Setting->System->General->General, you can enable/disable
startup wizard.
Step 1 Click Next.
Enter login interface. See Figure 4-13 or Figure 4-14.
Note
In Figure 4-12, click Cancel button, device enters login interface. See Figure
4-13. After login, device goes to multiple-window preview mode by default.
If you have not set unlock pattern, the interface is shown as in Figure 4-14.
To Next Page
Loading...
