Five times login failure may result in account lock. For each login failure,
system pops up remain attempt amount.
In case you forgot unlock pattern, click Forgot unlock pattern in Figure 4-13.
Device goes to Figure 4-14 for you to input password.
4.1.4.1 General
Besides startup wizard and configuration wizard, from main
menu->Setting->System->General, you can also go to the General interface too.
4.1.4.1.1 General
Step 1 Click General tab.
Enter General interface. See Figure 4-15.
Step 2 Set parameters.
Device ID: Please input a corresponding device name here.
Device No: Here you can set device number.
Language: System supports various languages: Chinese (simplified), Chinese
(Traditional), English, Italian, Japanese, French, Spanish (All languages listed here
are optional. Slight difference maybe found in various series.)
Video standard: There are two formats: NTSC and PAL.
HDD full: Here is for you to select working mode when hard disk is full. There are two
options: stop recording or rewrite. If current working HDD is overwritten or the current
HDD is full while the next HDD is no empty, then system stops recording, If the
current HDD is full and then next HDD is not empty, then system overwrites the
previous files. Please note, DVR will not overwrite the locked files. Please refer to
chapter 0 to lock or unlock a file.
Pack duration: Here is for you to specify record duration. There are two ways for you
to set.
Time length: It is to pack according to time. The value ranges from 1 to 60 minutes.
Default value is 60 minutes.
File length: It is to pack according to file length. The default setup is 1024M. The
value ranges from 128M to 2048M.
Instant playback: It is to set playback time you can view in the preview interface. The
value ranges from 5 to 60 minutes.
Auto logout: Here is for you to set auto logout interval once login user remains
inactive for a specified time. Value ranges from 0 to 60 minutes.
IPC Time Sync: You can input an interval here to synchronize the DVR time and IPC
time.
Navigation bar: Check the box here, system displays the navigation bar on the
interface.
Startup wizard: Once you check the box here, system will go to the startup wizard
directly when the system restarts the next time. Otherwise, it will go to the login
interface.
Mouse sensitivity: You can set double click speed via dragging the slide bard. You
can Click Default button to restore default setup.
To Next Page
Loading...
