Figure 4-15
Step 3 Click Apply or Save to complete setup.
4.1.4.1.2 Date and Time
Step 1 Click Date and Time tab.
Enter date and time interface. See Figure 4-16.
Step 2 Set parameters.
Date format: There are three types: YYYYY-MM-DD: MM-DD-YYYYY or
DD-MM-YYYY.
Date separator: There are three denotations to separate date: dot, beeline and
solidus.
DST: Here you can set DST time and date. Here you can set start time and end time
by setting corresponding week setup or by setting corresponding date setup.
NTP: It is to set NTP server information. Check the NTP box to enable this function.
Host IP: Input the server IP that installed the NTP server.
Manual update: Click it, you can sync DVR time with the NTP server manually.
Port: System supports TCP transmission only. The port value is 123.
Interval: It is to set the sync time interval between the DVR and the NTP server. The
value ranges from 0 to 65535 minutes.
To Next Page
Loading...
