Web Operations 196
Alarm Output Figure 5-80
Select alarm output mode. Step 2
Manual: After the alarm linkage is configured, no matter whether there is an alarm
event occurs, the corresponding alarm output port keeps generating alarm.
Auto: After the alarm linkage is configured, only when there is an alarm event
occurs, the corresponding alarm output port generates alarm.
Stop: After the alarm linkage is configured, no matter whether there is an alarm
event occurs, the corresponding alarm output port never generate alarm.
Click Save. Step 3
Status: Indicates the status of each alarm output port. indicates there is alarm
output, and indicates there is no alarm output.
5.3.3.5 Configuring Face Detection
You can enable the face detection function for Channel 9 to Channel 12. The system
automatically detects the faces and takes snapshots for the corresponding channel.
Select SETUP > EVENT > DETECT > Face Detection. Step 1
The Face Detection interface is displayed, see Figure 5-81.
Face Detection Figure 5-81
In the Channel list, select the channel that you want to enable the face detection Step 2
function.
Select the Enable check box. Step 3
Click Save. Step 4
To Next Page
Loading...
Need help?
General