Local Configurations 122
Default Figure 4-108
Select the functions that you want to restore to default. Step 2
Clear Config: Click Clear Config, the system pops up a message indicating that
the Device will reboot if you continue the operation. Click OK to start rebooting.
After the Device is rebooted, except the IPV4 address information and added user
information, all the other configurations will return to the default.
Restore the factory settings after the Device is rebooted, except the IPV4 address
information, all the other configurations will return to the default, and the Device
requires initialization again in next rebooting. Please operate with caution.
The restore options: Select the check box of the functions that you want to restore
to default, and then click OK.
For example, select the NETWORK check box, and then click OK. The Device IP
address will restore the default IP address.
Select the Select All check box to restore all the functions to the factory default.
4.4.5 Upgrading System
You can upgrade the firmwares by connecting the external storage device which provides the
upgrade package.
Preparation
The external storage device with upgrade package is connected to the Device.
Procedure
Select Main Menu > INFO > VERSION. Step 1
The VERSION interface is displayed. See Figure 4-109.
To Next Page
Loading...
Need help?
General