Installation 14
Video output
The Device is provided with one CVBS (PAL/NTSC 1.0V
P-P
, 75Ω) port and VGA port, and
supports the simultaneous output from these two ports.
Read the following contents carefully before using the computer instead of monitor.
For VGA output, you need to prepare a VGA adapter cable to connect to computer.
To extend the Device life, do not keep the Device running for a long time.
Regular demagnetizing helps keep the monitor working properly.
Stay away from devices with strong electromagnetic interference.
Audio output
The audio output signal parameter is larger than 200mv 1KΩ. The audio output port can directly
connect to the display with audio function on the vehicle or active speaker, and the port can
also drive other sound output devices through amplifier.
Alarm Input and Output Connection 2.6
Before using the alarm function, learn about the connections method of alarm input and output
port.
Alarm Input
The alarm input port supports alarm signal from ground and device of 12V–24V voltage.
If the alarm device is connected to the Device and other devices, use relay for isolation.
Alarm Output
The alarm output port cannot be connected to high-power load (less than 1A). When
constructing the output circuit, the excessive current should be prevented from causing
damage to the relay. Use the contactor for isolation when applying high-power loads.
PTZ Decoder Connection
The common-ground must be prepared for PTZ decoder and the Device; otherwise the
common-mode voltage might not be able to control the PTZ. It is recommended to use
shielded twisted pair, and the shielding layer can be used for common ground.
Prevent interference from high-voltage power, make reasonable wiring, and take measures
for lighting protection.
Remotely import 120Ω to reduce resistance reflection and protect the signal quality.
The Device RS-458 A line and B line cannot connect to other RS-485 output device in
parallel.
The voltage between the A line and B line must be less than 5V.
Front-end Device Grounding
The bad grounding might result in chip damage.
To Next Page
Loading...
Need help?
General