Web Operations 217
The corresponding functions will be restored to the factory default, and your current
configurations will be lost. Please operate with caution.
Select SETUP > SYSTEM > DEFAULT. Step 1
The Default setting interface is displayed. See Figure 5-110.
Factory default setting Figure 5-110
Select the check box of the options that you want to restore to the factory default. Step 2
Default: Select the options, and then click Default. In the pop-up message, click
OK. The selected options will be restored to the factory default settings.
Restore the factory settings: Click Restore the factory settings. In the pop-up
message, click OK. The system starts rebooting. After the Device is rebooted,
except the IPV4 address information, all the other configurations will return to the
default, and the Device requires initialization again in next rebooting. Please
operate with caution.
When there is a user operating on the local interface, the factory default settings
cannot be performed until the local user log out.
5.4.5 Upgrading System Firmware
You can import the upgrading file to upgrade the system. The supported upgrade file format
is .bin.
During upgrading, do not disconnect from power and network, and reboot or shut down the
Device.
Upgrading the wrong file might result in the Device not working properly.
Select SETUP > SYSTEM > UPGRADE.
Step 1
The System Upgrade interface is displayed. See Figure 5-111.
System upgrade Figure 5-111
In the chiplist list, select Main or MCU according to the actual situation. Step 2
Main: Upgrade the system program.
MCU: Upgrade the MCU firmware program.
To Next Page
Loading...
