Instruction SiEN18-622
202 System Configuration
Outdoor Unit
Indoor Unit
Outdoor Unit
Appearance of the outdoor unit may differ from some models.
1. Photocatalytic deodorizing filter and Air
purifying filter:
• These filters are attached to the inside of
the air filters.
2. Air outlet
3. Display
4. Front grille
5. Louvers (vertical blades):
• The louvers are inside of the air outlet.
6. Air inlet
7. Air filter
8. Flap (horizontal blade)
9. Operation lamp (green)
10.TIMER lamp (yellow)
11.HOME LEAVE lamp (red)
12.Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push it once again to stop it.
• The operation mode refers to the following
table
.
• This switch is useful when the remote
control is missing.
13. Signal receiver:
• Signals are received from the remote
control.
• When the unit receives a signal you will
hear a short beep.
• Operation start .............beep-beep
• Settings changed..........beep
• Operation stop..............beeeeep
14. Air outlet selection switch
15. Room temperature sensor:
• It senses the air temperature around the
unit.
16. Air inlet:
(Back and side)
17. Refrigerant piping and inter-unit cable
18. Drain hose
19. Earth terminal:
• It is inside of this cover.
20. Air outlet
17
18
19
20
16
Mode
Temperature
setting
Air flow
rate
AUTO 25°C AUTO
To Next Page
Loading...
