TWO-HEAD DIMENSIONING SYSTEM REFERENCE MANUAL
Head Pitch
Estimate 1 and 2
Enter Head Pitch Estimate 1 (HEAD1) and Head Pitch Estimate 2
(HEAD2) based on the angles from the application specifications.
This will be a positive degree integer for each head (no negative
degree indication). The Head Pitch Estimate helps each head
differentiate the conveyor bed from the beam catcher.
Click Find Belt to automatically determine the Scanner Heights,
Left Ignore, Right Ignore, X Shift, Y Shift, and X Rotation.
NOTE: When Find Belt is clicked, the system calculates
each dimensioner’s position over the conveyor.
If the data from each dimensioning head does not agree, the
following warning may appear:
WARNING: heads disagree on belt width by more than 5cm
[2”]
The calculated data is automatically entered in the Find Belt fields
under Dimensioning Area
To Next Page
Loading...