Setting Up the Reader
Product Reference Guide
11
Table 1. Radio Base LEDs
Charging the Battery Pack
To charge the battery, simply insert the QuickScan reader into the base. When
the scanner is fully seated in the cradle, it will sound a “chirp” to indicate that
the cradle has detected the scanner connection.
The LEDs on the base (shown in
Table 1 on page 11
) will indicate the status of the
battery.
Alternatively, the battery can be charged by connecting the reader directly to a
host or a wall adapter through the micro-USB connector in the bottom of the
handle, as shown.
LED STATUS
Power on
/ Data
Yellow On = Base is powered
Yellow Blinking = Base receives data and commands from
the Host or the Reader.
Charging Red On = the Battery is charging.
Charge
completed
Green On = the Battery is completely charged.
Charging +
Charge
completed
Red and Green Blinking together = the Reader is not cor-
rectly placed onto the Base.
NOTE
Before using the battery, read “Battery Safety” in the following section. Datalogic rec-
ommends annual replacement of rechargeable battery packs to ensure maximum per-
formance.
To Next Page
Loading...
