EasyManuals Logo
Home>Datalogic>Barcode Reader>QuickScan I QBT21X1

Datalogic QuickScan I QBT21X1 User Manual

Datalogic QuickScan I QBT21X1
362 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #309 background imageLoading...
Page #309 background image
Reading Parameters
Product Reference Guide
299
Scan Mode
Selects the scan operating mode for the reader. Selections are:
Trigger Single:
When the trigger is pulled, scanning is activated until one of the
following occurs:
Scanning Active Time on page 83
has elapsed
a label has been read
the trigger is released
This mode is associated with typical handheld reader operation: when the trig-
ger is pulled, scanning starts and the product scans until the trigger is released,
or a label is read, or the maximum
Scanning Active Time on page 83
has elapsed.
Trigger Hold Multiple :
When the trigger is pulled, scanning starts and the product
scans until the trigger is released or
Scanning Active Time on page 83
has elapsed.
Reading a label does not disable scanning.
Double Read Timeout on page 70
pre-
vents undesired multiple reads of the same label while in this mode.
Trigger Pulse Multiple:
When the trigger is pulled, continuous scanning is acti-
vated until
Scanning Active Time on page 83
has elapsed or the trigger has been
released and pulled again.
Double Read Timeout on page 70
prevents undesired
multiple reads of the same label while in this mode.
Flashing:
The reader flashes
1
on and off regardless of the trigger status. Flash
rate is controlled by
Flash On Time on page 84
and
Flash Off Time on page 85
. When
Flash is ON the reader reads continuously. When Flash is OFF scanning is deac-
tivated.
Always On:
No trigger pull is required to read a bar code. Scanning is continually
on.
Double Read Timeout on page 70
prevents undesired multiple reads while in
this mode.
Autosense
®
Stand Mode:
No trigger pull is required to read a bar code. Scanning
is turned on automatically when an item is placed in readers field of view. If the
trigger is pulled, the reader acts as if it in single read mode.
Double Read Timeout
on page 70
prevents undesired multiple reads of the same label while in this
mode.
Trigger Object Sense:
This mode is similar to Stand Mode, except that a trigger
pull is required to activate the decoder.
1. Controlled by
Flash On Time on page 84
.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datalogic QuickScan I QBT21X1 and is the answer not in the manual?

Datalogic QuickScan I QBT21X1 Specifications

General IconGeneral
BrandDatalogic
ModelQuickScan I QBT21X1
CategoryBarcode Reader
LanguageEnglish

Related product manuals