Enter/Exit Programming Mode USB-OEM Device Usage
54 QuickScan™ I QM21X1 / QBT21X1
USB-OEM Device Usage
The USB-OEM protocol allows for the reader to be identified as one of two dif-
ferent types of bar code readers. Depending on what other scanners you may
already have connected to a USB-OEM POS, you may need to change this setting
to enable all devices to communicate.
Options are:
• Table Top Scanner
• Handheld Scanner
USB-OEM Interface Options
This setting provides for an interface specific control mechanism..
Options are:
• Obey — Obey Reader Configuration Host Commands
• Ignore — Ignore Reader Configuration Host Commands
NOTE
It may be necessary to switch device usage when connecting two readers/
scanners of the same type to a POS system.
$CIBUT00
USB-OEM Device Usage = Table Top Scanner
$CIBUT01
USB-OEM Device Usage = Handheld Scanner
$CIFO101
USB-OEM Interface Options = Obey
$CIFO102
USB-OEM Interface Options = Ignore
To Next Page
Loading...
