290 QuickScan™ I QM21X1 / QBT21X1
characters in
Appendix D, Keypad
representing your desired character(s). If less
than the expected string of 20 characters are selected, scan the ENTER/EXIT bar
code to terminate the string. Reference the section,
"Example: Setting a Prefix"
on
page 289, for more information. Exit programming mode by scanning the
ENTER/EXIT bar code once again.
Global AIM ID
AIM label identifiers (as opposed to custom characters you select yourself as
with label identifiers) can be included with scanned bar code data. AIM label
identifiers consist of three characters as follows:
• A close brace character (ASCII ‘]’), followed by...
• A code character (see the table below), followed by...
• A modifier character (the modifier character is symbol dependent).
Figure 9. AIM ID
NOTE
This feature enables/disables addition of AIM IDs for all sym-
bology types.
SYMBOLOGY CHAR SYMBOLOGY CHAR
UPC/EAN
E
a
a. UPC-A and UPC-E labels are converted to EAN 13 when adding AIM
IDs.
Code 128/GS1-128
C
Code 39 and
Code 32
A
GS1 DataBar Omnidirec-
tional, GS1 DataBar
Expanded
e
Codabar
F
Standard 2 of 5
S
Interleaved 2 of 5
I
ISBN
X
b
b. ISBN (X with a 0 modifier character)
Code 93
G
Code 11
H
Prefix SuffixLabel ID Label IDBar Code DataAIM ID
To Next Page
Loading...
Need help?
General
