(Continued from previous page)
6-4-3 New Added No.37
6-4-4 Change termination number of “COUNT / D-No.”
6-4-5 Change termination number of “COUNT / D-No.”
6-4-6 Added examples during a fastening operation
6-5-2 Change termination number of “COUNT / D-No.”
6-6 Delete CF card Format
6-7-2 Added action when rate increase angle is “0”
Change explanation of Break Away Torque Check
Added current value of motor type M120
Rename fastening parameters
D-No.520 [Full Scale Current Value] → [No Load Current Limit]
D-No.521 [Low Current Limit] → [Low Current Warning]
D-No.522 [High Current Limit] → [High Current Warning]
6-8-1 New Added SYS-030
New Added SYS-410～413
New Added SYS-504
Changed description SYS-035 *****1
：
Prohibition of Resume after Total Accept Relay
New Added SYS-035 ****1*：Initial Positon of Fastening Result Mode
New Added SYS-035 ***1**：Display Stop Status
New Added SYS-035 *1****：TB2-2_CF warning signal output
New Added SYS-035 1*****：Special Function 1
Changed description SYS-400
6-8-2 Changed description D-No.211
Rename fastening parameters
D-No.520 [Full Scale Current Value] → [No Load Current Limit]
D-No.521 [Low Current Limit] → [Low Current Warning]
D-No.522 [High Current Limit] → [High Current Warning]
New Added D-No.548～549
New Added D-No.589～599
Changed description D-No.209 Correction Angle
Changed description D-No.520,523
Added Notes on Recovery pulse operation
Added PLC I / O output signal to batch sequence program example
7-1 New Added A02(Unused), A07(Unused)
7-2-2 New Added A02(Unused)
7-2-3 New Added A.03-05 Watchdog Timer Error
7-2-7 New Added A07(Unused)
7-2-8 Change cause of A.08-02 Watchdog Timer Error
Delete A.08-06 Source Voltage Error
Change cause of A.08-07 Control Power Voltage Drop Error
A.08-08 Changed Over Speed to System Error
7-2-9 Added A.09-08 Reverse Torque Error
New Added A.09-13 Work Selection Error
7-4 Review items
8-1 Review document composition
8-1-6 Added LED lighting condition
8-3 Added How to change the extended RS232C port setting
New Added ID Data Input Setting
9-1-1 New Added ID SELECT ENABLE
New Added CF WARNING
New Added BATCH SEQ END
9-3-6 New Added System Area PLC Handshake
To Next Page
Loading...