Dell Command Line Interface User Manual

190 Working With CLI Command Results
The available formats include:
• List (lst)
• Semicolon-separated values (ssv)
• Table (tbl)
• Raw xml (xml)
• Custom delimited format (cdv)
Syntax for the formatting option is:
<command> -fmt <format option>
For example, type:
omreport system summary -fmt tbl
where -fmt tbl specifies table format.
You can combine the formatting option with the option to direct output to a file. For example, type:
omreport system summary -fmt tbl -outa summary.txt
where -fmt tbl specifies table format and -outa specifies that you append the command results to a file
called summary.txt.
List (lst)
The default format is lst or list format. Use this format when you want to optimize output for simple
readability. You need to specify a format for your command output only if you want a format other than
lst format.
To see the following example command output in lst format, type:
omreport system summary
No special formatting option is required because list format is the default display format. The network
data part of the example system summary appears as follows:
--------------
Network Data
--------------
Network Interface Card 0 Data
IP Address: 143.166.152.108
Subnet Mask: 255.255.255.0
Default Gateway: 143.166.152.1
MAC Address: 00-02-b3-23-d2-ca

Dell Command Line Interface Specifications

General

Brand	Dell
Model	Command Line Interface
Category	Network Card
Language	English